This is what the first part of my drawing looked like when it was first extruded and the first half of it had walls sketched onto the maze.
This is what it looked like when I finished drawing the walls on the maze, now the only thing left to do is extrude the walls into the maze which would create the path ways.
This what the final product after I extruded the path ways into the maze on inventor.
This is what the maze looked like when I put it into Fusion 360 for the first time.
This is what it looked like when I was setting up the tool in Fusion 360.
In this picture the router is zeroing its self with the center of the project. This happens when I use the controls to to bring it over to the zero point and then I click zero.
This is the router when I had all the zeroing and setups done and it is cutting out my paths into the foam which then will create my maze.
This is what my maze was like when it was completely routed into the foam.